1. Dry strength
The bond strength measured after drying is specified under specified temperature and humidity conditions.

2. Wet strength
Under the specified conditions, the bonding strength of the glue sample is soaked in the liquid and removed immediately.

3. Damage rate of wood
Refers to the failure degree of wood fiber on the glued interface during the strength test of wood glued products. Usually, it is expressed by the percentage of broken parts and the total white area.

4. Fatigue test
Under the prescribed frequency condition, the test results of the mechanical properties of the bonded specimens subjected to alternating load and the failure of the joints are caused.

5. Fatigue life
Under the specified load and frequency conditions, the number of alternating stress cycles causing the failure of glued specimens is determined.

6. Damage test
Tests to test the strength of a glued specimen by destroying it.

7, nondestructive test
Test of bonding quality without damaging the adhesive sample

8, weatherability test
Tests were carried out to test the performance of glued samples exposed to white or similar conditions.

9, high and low temperature alternating test
The test of the performance change of the glued product sample after the specified cycle of high temperature and low temperature is carried out.

10. Accelerated aging test
The aging tests designed to simulate the long-term use conditions are designed in a short time.

11, impregnation test
The adhesive samples were placed in water or other solvents at a certain temperature for a period of time. After that, the adhesive properties of the samples were measured.

12. Boiling test
According to the stipulated time, the test of the bonding strength of the glued samples in boiling water was determined.

13. Adhesive parts
The adhesive bonded assembly has been completed.

14. Honeycomb core
Honeycomb material made of metal foil, paper or fiberglass cloth and other skeleton materials and adhesives. It is used to make honeycomb sandwich structure and so on.

15, interlayer structure
The structure of two layers of panel materials is clamped with a layer of core material, such as honeycomb core, foam plastic, corrugated board, etc.

16. Adhesive joint
Place two adjacent stickies glued together with adhesive.

17, laminated products
Products made from two or more than two layers of glue.
The above is provided by the terminating tape manufacturer.